Page 1 of 1
WTB: Playchoice 10 parts
Posted: Thu Jan 04, 2018 9:45 am
by mdesfosses
Hi,
I am looking for PC10 dual monitor parts such as:
Control Panel
Marquee
Monitor - Sanyo 20EZ
Wiring Harness
Thanks !
Re: WTB: Playchoice 10 parts
Posted: Tue Jan 09, 2018 2:15 am
by XeD
Where are you located? Are you looking for 20ez chassis or complete monitor
Re: WTB: Playchoice 10 parts
Posted: Wed Jan 10, 2018 1:16 pm
by mdesfosses
I am near Montreal, Quebec. I am looking mainly for the tube. I have a functional monitor but with severe burn and low brightness. I tested the tube with a crt tester and it definitely is dying.
Re: WTB: Playchoice 10 parts
Posted: Wed Jan 10, 2018 6:03 pm
by XeD
That suck. Those tube are getting harder to come by.
Re: WTB: Playchoice 10 parts
Posted: Thu Jan 11, 2018 3:21 pm
by Robert
Have you ever done a Tube swap, there lots of TVs that used the same tubes as monitor`s from 80 90`s... i did a swap on my Nintendo monitor EZ20 ( a
Goldstar 1991 19 inch tube)... there a lot of 19 inch tubes are CR-23 Socket and same pin-out , just got to find one with the same yoke same or close OHM reading ,,their a great cross reference chart people have been adding to
http://junknet.net/donor-tvs
Re: WTB: Playchoice 10 parts
Posted: Thu Jan 11, 2018 3:35 pm
by Robert
this another trick that not 100% fool prof but it works for the poor man How to convert a 56 ohm vertical yoke to 15 ohms