menace wrote:ask me how I know this LOL
How do you know this?
Moderators: machine.slave, Doc Kaos, mark, jasonec, CongoBongo, monkeybug
menace wrote:ask me how I know this LOL
Zippy3000 wrote:Can't do that either. It's not my house ... It's the landlord's ... I don't think he's too keen on spending money to get a wider door put in just to satisfy my need to get an arcade machine into my apartment. It's also an annoying situation because the door frame is built on an angle... So in actual fact, the with the door on, it only opens about 45 degrees.
If the door wasn't on an angle, and I could go striaght in, i bet it would fit no problem. But that would involve reconstructing part of the wall, and getting a new door and frame.
You can see i'm in quite a bind here ... This is why I was considering taking the cabinet apart.
This would be less work than taking the cab apart.GodSend wrote:If its really "THAT CLOSE" you MIGHT be able to pop the door off the hinge and then remove the door jam on the striker side. Pop off the trim first a and run a sawzall between the jam and the rough opening stud and sawzall the top and bottom. If you're careful you can reuse, or if not a piece of pine from lowes should run you 10$. Its a bit of pain, but you should be able to do it in a few hours. Heck, when you pop the trim off you might realize the door jam is far enough away from the stud that its filled in with expanding foam, giving you even a few more inches.
GodSend wrote:If its really "THAT CLOSE" you MIGHT be able to pop the door off the hinge and then remove the door jam on the striker side. Pop off the trim first a and run a sawzall between the jam and the rough opening stud and sawzall the top and bottom. If you're careful you can reuse, or if not a piece of pine from lowes should run you 10$. Its a bit of pain, but you should be able to do it in a few hours. Heck, when you pop the trim off you might realize the door jam is far enough away from the stud that its filled in with expanding foam, giving you even a few more inches.
Zippy3000 wrote:Thanks for the ideas.
I can mention the sawzall idea to the contractor. I'm hoping that any decent contractor will have a positive attitude and do what it takes to get the job done.
jasonec wrote:With those limitations, you should really look into getting a cabaret arcade cabinet instead of a full-sized one....
scogon wrote:sounds like it's time to move....
Zippy3000 wrote:Thanks for the ideas.
Yeah, i had pretty much decided to try paying a contractor to remove the door frame ... It's a metal fire/security door, and unfortunately, i'm pretty sure it's going to get wrecked when it comes off ... so i'll have to buy a new one. I'm counting on at least another 1/2 inch total width by getting the frame off ... I feel like that *might* be enough to get the machine through the door ... Sadly, short of creating a scale 3D model of the whole situation, I think I just have to risk it and hope for the best.
I can mention the sawzall idea to the contractor. I'm hoping that any decent contractor will have a positive attitude and do what it takes to get the job done. To be clear, are you suggesting to actually cut the stud out? and then replace? I think that would also involve re-drywalling but, if that's what it takes I might still do it.
The only sh*tty thing about this whole ordeal, is that all of this would need to be done again whenever we move ... fortunately, our rent is fairly low, and our landlord likes us ... We've already been here for 8 years, and at the moment there is no reason to believe that we couldn't stay for quite a while longer.
Users browsing this forum: No registered users and 38 guests