Hi,
I replaced the HOT on a dead Pentranic CH-281, and I now have a picture. However, the horizontal size is too wide and the horizontal position makes the picture distort and stretch about a fourth of the way down the screen.
I measured the B+, and it's currently at 155v instead of the 115v as listed in the schematic.
Schematic is available here:
http://slot-tech.com/amusements/moni.../pentranic.jpg
Adjusting the B+ potentiometer doesn't change anything, B+ stays at 155v.
Any pointers?
Thanks!
SOLVED: Pentranic CH-281 B+ issue
Moderators: machine.slave, Doc Kaos, mark, jasonec, CongoBongo, monkeybug
SOLVED: Pentranic CH-281 B+ issue
Last edited by mdeslaur on Thu Jul 26, 2018 3:30 pm, edited 1 time in total.
Re: Pentranic CH-281 B+ issue
Schematic doesn't seem to work. I would guess another component but have you checked to make sure the pot works? Just turn off the Mon and use ohm setting on your mm should be able to make sure the pot itself still functions.
Re: Pentranic CH-281 B+ issue
Oh, bad URL. Here is the right schematic URL:
http://slot-tech.com/amusements/monitor ... tranic.jpg
Yes, I've checked the pot.
http://slot-tech.com/amusements/monitor ... tranic.jpg
Yes, I've checked the pot.
Re: SOLVED: Pentranic CH-281 B+ issue
Solved: bad Q801, bad R808, bad R806.
Who is online
Users browsing this forum: No registered users and 30 guests