Wtb, NBA Jam 3p, 4p kick harnesses..

[trueno92]

So... looking for these..

The accessory harnesses for players 3 and 4

[theyangman]

Are you Eh Lee on FB?

[trueno92]

Are you Eh Lee on FB?

Nailed it

What's up tony.

[hell_rod]

If no one locally can help you out there is a guy who goes by jason_971 on the KLOV forum who makes them. Never bought anything from him but the reviews appear to be pretty good.

[b1buwg97]

I have a full 4 player blitz harness (which is the same) and a blitz board you could play football instead of the BB (which SUCKS) I kid

Anyway LMK got anything to trade?

[trueno92]

Thanks b1, maybe a full harness and blitz pcb would make for a nice multi...

Traded my neo Geo stuff for this 4p cp.. so all I got is alcohol and a bit of paper green stuff...

I have the individual harnesses from each player that go to individual molex connectors, so I'm gonna see about tracing the pinouts and make my own harnesses for 3p and 4p.

Been playing too much ghetto pinball to give this project priority...

[trueno92]

Woot woot, looks like its possolible to make the kick harnesses from the factory stuff, midway used some configurable molex connectors!

[trueno92]

Booyah!

It is 400% possible to make the harnesses if you have the ones that come with the cp.

400% because you can make 4 of them, you only need players 3/4 but u have enough 1 for each harness that goes to each player. Its just a matter of moving the order of 2 wires on p3 and 4 wires on p4. Leave the ground pin on the main pcb header disconnected as the molex won't be long enough to reach. Then take the p1 unified ground and tie it anywhere into your cabinets p1 wiring and it will effectively ground your p3/p4 harness.

Now to figure out how to bolt this up to the cab!